GAMEMAX FN12A-S8I 120mm ARGB Case Fan - Black Frame / Infinity RGB Lighting Effect / PWM Intelligent Speed Control (800–1600 RPM) / Dual-Sided Addressable RGB LEDs / 5V 3-Pin ARGB + 4-Pin PWM Support / Aura Sync Compatible / Ultra-Quiet Operation (Max 31.21dBA) / 8× Shock-Absorbing Rubber Pads / Stable & Efficient Cooling Performance / FN12A-S8I

The GAMEMAX FN12A-S8I measures 120 x 120 x 25mm and pairs a black frame with nine semi-transparent white blades. The contrast is deliberate: the dark frame disappears against a black chassis while the pale blades act as a diffuser, so the lighting reads as a bright ring rather than a set of individual points behind tinted plastic.

LEDs are fitted on both sides of the fan, which is what produces the infinity lighting effect. Light reflects between the two illuminated faces and appears to run deeper into the fan than its 25mm thickness allows. It also means the fan looks finished from either side, so it does not matter which way it ends up facing.

The lighting is split across two independently addressable zones, eight LEDs in the centre hub and sixteen in the outer ring, for twenty-four in total. Because each diode is addressed separately, the outer ring can run a moving pattern while the hub holds a solid colour underneath, instead of the whole fan being locked to one shade.

Lighting connects through the standard 5V 3-pin addressable header and is compatible with Aura Sync. That puts the fan under the same control software as the rest of the build, so the memory, cooler and fans all follow one profile. No separate controller or extra utility is needed if your motherboard has an addressable header.

A 4-pin PWM connector hands speed control to the motherboard across an 800 to 1600 RPM range within a 10 percent tolerance. The fan then follows a temperature curve rather than a fixed setting, holding a low speed through browsing and office work and lifting only when a game or an export genuinely raises component temperatures.

Airflow peaks at 44.35 CFM with a 10 percent tolerance, which is a strong number for a 25mm-thick 120mm fan. That is the volume of air exchanged inside the case each minute, and it is what keeps the pocket of hot air above a graphics card from simply sitting there and raising every temperature around it.

Maximum static air pressure is 1.42mmH2O. This is the specification that decides whether a fan still performs once something sits in front of it, such as a dust filter, a mesh front panel or a radiator. Airflow ratings are measured in free air, so static pressure is the more honest guide to how a fan behaves once installed.

The fan is rated at a maximum of 31.21dB(A), a figure it only reaches at 1600 RPM. Under a typical fan curve it spends most of its life nearer the 800 RPM floor, where it is effectively part of the room's background noise. The ceiling matters most in a build running several fans that all ramp together under load.

Eight shock-absorbing rubber pads isolate the fan from the panel it is screwed to, cutting the resonance that turns a quiet motor into an audible buzz. Inside, a hydraulic bearing rated at 30,000 hours mean time between failures carries the rotor on a fluid film, which is why it keeps running quietly as it ages.

Both leads are 500mm long, one 4-pin PWM power cable and one 3-pin ARGB cable, each with male and female ends so fans can be chained together. The fan is rated and tested at 12V, drawing 0.15A to a 0.18A maximum for 1.8W and a 2.16W peak, and it starts from 5V. Mounting screws are included.